Applying vehicle graphics isn't difficult but can be a little tricky so make sure to take your time. We've included some additional resources to help you out.

Applying Vehicle Graphics (with pics)

1. Clean the area of the vehicle where you're applying your graphic with soap and water. Let this area completely dry.
2. Use masking tape to tape your graphic to the vehicle.
3. Use a tape measure to ensure your graphic is straight and centered.
4. Place a long strip of masking tape down the middle of the graphic.
5. Start from one end of the graphic, and peel away the backing material until your reach the tape in the middle.
6. Cut off the backing material you just peeled away.
7. Pull tightly on your graphic as you stick it to the vehicle one section at a time while smoothing it with a white squeegee. If you don't have a white squeegee, you can use a credit card or your hand as a substitute. Smoothing out your graphic helps to get rid of any air bubbles that may form.
8. Repeat steps 5-7 for the other end of your graphic.
9. Once you have applied the entire graphic to the vehicle, carefully peel back the application tape by starting at a corner and pulling it at an angle.